Infinity Kappa Perfect 600 6-1/2″/6-3/4″ component speaker system

  • Mô tả

Mô tả sản phẩm

Hands-on research

Features and Specs

General
Speaker Size6 3/4
Design2-way
Tweeter DesignEdge-Driven Dome
Tweeter CompositionPolyimide
Woofer CompositionCarbon Fiber
Woofer SurroundRubber
Parts Warranty3 Years
Labor Warranty3 Years
Specifications
Sensitivity90 dB
Frequency Response60 – 30k Hz
Minimum RMS Wattage
Maximum RMS Wattage100
Peak Power Handling (Watts)400
Impedance (Ohms)4
Top-mount Depth (Inches)2 7/8
Bottom-mount Depth (Inches)3 1/4
Cutout Diameter or Length (inches)5

Product Research

Features

Plus One Woofer Cones: The Plus One woofer cones offer more surface area than other speakers that fit in the same size opening. This is accomplished by using a new basket design and hi-roll surround. The result is greater bass output and a significant increase in efficiency.

Terminals: The woofers’ input terminals are set screws that will accept up to 14 gauge bare wire.

Woofer Size: Without an adapter, the woofers fit standard 6-3/4″ applications. They will also fit in standard 6-1/2″ speaker openings, but do not use the standard 6-1/2″ speaker bolt pattern. In order to install them in standard 6-1/2″ speaker openings you must drill new screw holes. If new holes are drilled in the mounting surface of the car, no bracket is needed. If drilling in the car is not an option, the included brackets can be used, which have standard 6-1/2″ mounting holes, the Ford non-symmetric four hole pattern, and other 6-1/2″ and 6-3/4″ patterns. When using the brackets the depth becomes 2.643″ and the mounting height becomes 0.77″.

Tweeter Mounting: Using the included housings the tweeters can be flush mounted or surface mounted. The tweeter can pivot in the flush mount housing, so it can be directed to optimize imaging.

Tweeter Dimensions:

Flush MountSurface Mount
Mounting Height0.473″1.33″
Mounting Depth1.383″screw depth
Frame Diameter2.661″2.25″
Cutout Diameter2.125″N/A

Crossovers: The crossovers can be set to 2-way (the default position, for use with the included woofer and tweeter) or 3-way (for use with the included drivers plus the optional midrange, sold separately). Each crossover also has a tweeter output level switch (choose between high and low output). The inputs and outputs are screw terminals that will accept bare wire or spade connectors up to 0.275″ wide. There are four mounting holes in the base of each crossover.

Crossover Dimensions:

  • Length: 5-1/2″
  • Width: 7-15/16″
  • Height: 1-5/8″